2003 ICC ANSI A117.1 PDF

Trademarks: “ICC,” the International Code Council logo and “Accessible and Usable Buildings and Facilities (ICC/ANSI Al )” are trademarks of the. The edition of ANSI Standard A presented the first criteria for requirements and identify changes from the edition. . ICC/ANSI A ICCANSIAAccessible and Useable Buildings and Facilities-The specifications in this standard make sites, facilities, buildings and elements accessible.

Author: Gut Dougore
Country: Nepal
Language: English (Spanish)
Genre: Travel
Published (Last): 5 September 2006
Pages: 197
PDF File Size: 19.50 Mb
ePub File Size: 17.33 Mb
ISBN: 709-6-47634-616-1
Downloads: 69884
Price: Free* [*Free Regsitration Required]
Uploader: Zugal

Curb ramps and the flared sides of curb ramps shall be located so they do not project into vehicular traffic lanes, parking spaces, or park- ing access aisles.

Access aisles shall be at the same level as the parking spaces they serve. Each grab bar shall be 24 inches mm minimum in length, located 24 inches mm maximum from the head end wall and extend to 12 inches mm maximum from the control end wall.

Call buttons and keypads shall be located within one of the reach ranges specified in Sectionmeasured to the cen- terline of the highest operable part.

The turning space shall be permitted to include knee and toe clearance complying with Section Application and Administration Definitions W117.1 from and sold by Amazon. Accessible bathtubs shall comply with Section The height of water closet seats shall be 11 inches mm minimum and 17 inches mm maximum above the floor, measured to the top of the seat.

State Building Code – ICC/ANSI A Code Interpretations

Accessible drinking fountains shall comply with Sections and Drive up Only automatic teller machines and fare machines shall not be required to comply with Section For bathtubs without permanent seats, grab bars complying with Section In Type A units, a shower seat is not required to icc installed where reinforce- ment complying with Section The dip of the overflow shall not be considered in determining knee and toe clearances.


Removable in-tub seats shall be 15 inches mm ansu and 16 inches mm maximum in depth.

Doors, doorways, and gates designed to be a1117.1 only by security person- nel shall not be required to comply with Sections A room or space in which people sleep that can also include permanent provisions for living, sleeping, eating, and either sanitation or kitchen facilities but not both. Accessible routes shall con- sist of one or more of the following components: Braille shall comply with Section A shower seat is not required to be installed in a shower facility for a single occupant, accessed only through a private office and not for common use or public use, provided reinforcement has been installed in walls and located so as to permit the installation of a shower 22003 complying with Section Marked crossings that are raised to the same level as the adjoining sidewalk shall be pre- ceded by a inch mm deep detectable warning complying with Sectionextending the full width of the marked crossing.

Where space beneath an element is included as part of clear floor space at an ele- ment, clearance at an element, or a turning space, the space shall comply with Section Unless specified otherwise, figures are not part of the Standard.

Full text of “ANSI A (): Accessible and Usable Buildings and Facilities”

Accessible routes required by the scoping provisions adopted by the administrative authority shall comply with the applicable provisions of Chapter 4. A seat wall, 24 inches mm minimum and 36 inches mm maximum in length, shall be provided on the entry side of asi compartment.


Power operated doors and gates shall remain open for 20 seconds minimum when activated. Where detectable warnings are provided on curb ramps, they shall comply with Sections Controls shall be located within one of the reach ranges specified in Section Other handrails shall comply with Sections Where pay telephones designed to accommodate a portable W117.1 are provided, they shall be equipped with a shelf and an electrical out- let within or adjacent to the telephone enclosure.

Guardrails or other barriers shall be provided where object protru- sion is beyond the limits allowed by Sections I highly recommended for people that have to go to site to check Aa117.1 guidelines.

The National Easter Seal Society and the President’s Com- mittee on Employment of People with Disabilities became members of the Secre- tariat, and the edition was reaffirmed in The verbal annun- ciator shall have a frequency of Hz min- imum to 3, Hz maximum.

Plumbing Elements and Icx 2. Distance between two hinged or pivoted doors in series shall be 48 inches mm minimum plus the width of any door swinging into the space.

2003 ICC Accessible and Usable Buildings and Facilities

Consensus requires that all views and objections be considered, and that a concerted effort be made toward their resolution. Operating instructions and ansii, visible transaction prompts, user input verification, error messages, and all displayed information for full use shall be accessible to and independently usable by individuals with vision impairments.

The clear length of the landing shall be 36 inches mm minimum.